Xử lý lỗi Loading ipmi trên VMware ESXi
fix VmWare ESXi boot stuck at ‘loading ipmi_si_drv’
Fix: loading module ipmi_si_drv esxi 6.0
HowTo: troubleshoot and fix VmWare ESXi boot stuck at ‘loading ipmi_si_drv’
Cách 1:
Step 1: Restart your machine. Its always good to go for the
‘when-nothing-works-try-this’ solution
Step 2: Be very quick and sharp about this step as it needs to be done in matter of seconds.
The moment you see a black screen with progress bar saying
LOADING HYPERVISOR , enter
SHIFT + o (the letter, not the number) instantly.
`shift + o’ is a directive to boot options of ESXi hypervisor.
Step 3: Now that you are on an interactive boot shell of ESXi, enter this command :
> noipmiEnabled
That will tell ESXi boot not to load ipmi drivers for next reboot.
* Careful, this you will need to do at every reboot of your machine
Step 4: now hit enter and and let it go through the booting process.
Step 5: watch without any panic , the ESXi now should load all modules except ipmi and there you are at login screen.
Cách 2:
First try setting IPMI to Shared in BIOS, if the option is available. When booting your installation media,
press Shift O to display the boot arguments and add noipmiEnabled to the boot arguments. Remember to do the same once the installation/upgrade is complete. Manually turn off or remove the module by turning the option VMkernel.Boot.ipmiEnabled off in vSphere or using the commands below:
# Do a dry run first:
esxcli software vib remove –dry-run –vibname ipmi-ipmi-si-drv
# Remove the module:
esxcli software vib remove –vibname ipmi-ipmi-si-drv
or try the following command in an unsupported shell connection:
esxcfg-module -d ipmi_si_drv
This disables the module although it still gets loaded.
Use a -l argument to see what modules are enabled/loaded and check that your desired one is disabled. This appears to be persistent across a reboot.
Suu tập từ nguồn Nước Ngoài