Chia Sẽ Kinh Nghiệm Về IT



Tìm Kiếm Với Google
-


9. Configuring IP Routing Protocol RIP, RIP v2, EIGRP, OSPF, VLSM Routing

Gởi Ðề Tài Mới  Gửi trả lời
 
Công Cụ Xếp Bài
Tuổi 11-08-2009, 11:04 PM   #1
adminphuong
Administrator
 
Avatar của adminphuong
 
Gia nhập: Jul 2009
Trả Lời: 152
Cấu hình IGRP cơ bản
Cấu hình IGRP cơ bản


Mô tả & yêu cầu

–Router 1, router 2 sử dụng IGRP để quảng cáo thông tin định tuyến
–Router 1 hoạt động như DCE cung cấp xung clock cho router 2
–Các router cấu hình IGRP và quảng cáo tất cả các mạng nối trực tiếp.
–Từ router 1, router 2 ping được hết các địa chỉ trong mạng.

Cấu hình

Router R1

hostname R1
!
enable password cisco
!
ip subnet-zero
no ip domain-lookup
!
interface Loopback0
ip address 192.168.4.1 255.255.255.0
!
interface Loopback1
ip address 192.168.5.1 255.255.255.0
!
interface Loopback2
ip address 192.168.6.1 255.255.255.0
!
interface Ethernet0
ip address 192.168.1.1 255.255.255.0
!
interface Serial0
ip address 192.168.3.1 255.255.255.0
clock rate 64000
!
router igrp 234
network 192.168.1.0
network 192.168.3.0
network 192.168.4.0
network 192.168.5.0
network 192.168.6.0
!
end

Router R2
!
hostname R2
!
enable password cisco
!
ip subnet-zero
no ip domain-lookup
!
interface Loopback0
ip address 192.168.7.1 255.255.255.0
!
interface Loopback1
ip address 192.168.8.1 255.255.255.0
!
interface Loopback2
ip address 192.168.9.1 255.255.255.0
!
interface Ethernet0
ip address 192.168.2.1 255.255.255.0
!
interface Serial0
ip address 192.168.3.2 255.255.255.0
!
router igrp 234
network 192.168.2.0
network 192.168.3.0
network 192.168.7.0
network 192.168.8.0
network 192.168.9.0
!
end

Các bước thực hiện

1. Đặt hostname, cấu hình cho các cổng loopback, ethernet và serial trên router R1

Router> en
Router# conf t
Router(config)# hostname R1
R1(config)# no ip domain-lookup
R1(config)# int e0
R1(config-if)#ip addr 192.168.1.1 255.255.255.0
R1(config-if)#no keepalive ← cho phép cổng Ethernet vẫn up khi không kết nối với bên ngoài
R1(config-if)# no shut
%LINK-3-UPDOWN: Interface Ethernet0, changed state to up
%LINK-5-UPDOWN: Line protocol on Interface Ethernet0, changed state to up
R1(config-if)# exit

R1(config)# int lo0 ← Định nghĩa cổng ảo để làm điểm kiểm tra
R1(config-if)# ip addr 192.168.4.1 255.255.255.0
R1(config-if)# int lo1
R1(config-if)# ip addr 192.168.5.1 255.255.255.0
R1(config-if)# int lo2
R1(config-if)# ip addr 192.168.6.1 255.255.255.0
R1(config-if)# exit

R1(config-if)# int s0
R1(config-if)# ip addr 192.168.3.1 255.255.255.0
R1(config-if)# clock rate 64000 ← hoạt động như DCE cung cấp xung clock
R1(config-if)# no shut

2. Đặt hostname, cấu hình cho các cổng loopback, ethernet và serial trên router R2

Router> en
Router# conf t
Router(config)# hostname R2
R2(config)# no ip domain-lookup

R2(config)#int e0
R2(config-if)# ip addr 192.168.2.1 255.255.255.0
R2(config-if)# no shut
R2(config-if)# int lo0
R2(config-if)# ip addr 192.168.7.1 255.255.255.0
R2(config-if)# int lo1
R2(config-if)# ip addr 192.168.8.1 255.255.255.0
R2(config-if)# int lo2
R2(config-if)# ip addr 192.168.9.1 255.255.255.0

R2(config-if)# int s0
R2(config-if)# ip addr 192.168.3.2 255.255.255.0
R2(config-if)# no shut

3. Cấu hình giao thức định tuyến IGRP và sau đó lưu cấu hình vào NVRAM trên router R1

R1(config)# router igrp 234 ← kích hoạt quá trình định tuyến IGRP trên router
R1(config-router)# network 192.168.1.0 ← chỉ ra mạng sẽ quảng cáo và xác định cổng nào sẽ gởi và nhận thông tin định tuyến RIP
R1(config-router)# network 192.168.3.0
R1(config-router)# network 192.168.4.0
R1(config-router)# network 192.168.5.0
R1(config-router)# network 192.168.6.0
R1(config-router)# end
R1#copy run start

4. Cấu hình giao thức định tuyến IGRP và sau đó lưu cấu hình vào NVRAM trên router R2

R2(config)# router igrp 234
R2(config-router)# network 192.168.2.0
R2(config-router)# network 192.168.3.0
R2(config-router)# network 192.168.7.0
R2(config-router)# network 192.168.8.0
R2(config-router)# network 192.168.9.0
R2(config-rputer)# end
R2# copy run start

5. Kiểm tra và giải quyết sự cố

Dùng lệnh clear ip route * để xoá toàn bộ route từ bảng định tuyến.

R1# clear ip route *

Xem quá trình gửi nhận thông tin định tuyến IGRP bằng lệnh debug ip igrp events, debug ip igrp transactions.

R1# debug ip igrp events
IGRP event debugging is on
R1# debug ip igrp transactions
IGRP protocol debuging is on
R1#
IGRP: received update from 192.168.3.2 on R2
IGRP: Update contains 0 interior, 4 system, and 0 exterior routes.
IGRP: Total routes in update: 4

Tắt chế độ debug bằng lệnh undebug all.

R1# undebug all
All possible debugging has been turned off

Xem bảng định tuyến trên R1 và R2 bằng lệnh show ip route.

R1# show ip route
Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, * - candidate default
U - per-user static route, o - ODR
Gateway of last resort is not set

I 192.168.9.0/24 [100/8976] via 192.168.3.2, 00:00:46, Serial0
I 192.168.8.0/24 [100/8976] via 192.168.3.2, 00:00:46, Serial0
C 192.168.3.0/24 is directly connected, Serial0
I 192.168.2.0/24 [100/8576] via 192.168.3.2, 00:00:46, Serial0
C 192.168.1.0/24 is directly connected, Ethernet0
I 192.168.7.0/24 [100/8976] via 192.168.3.2, 00:00:47, Serial0
C 192.168.6.0/24 is directly connected, Loopback2
C 192.168.5.0/24 is directly connected, Loopback1
C 192.168.4.0/24 is directly connected, Loopback0

Từ R1, bạn có thể thấy có 4 route IGRP học từ next-hop 192.168.3.2 và đi qua cổng S0. Chú ý số AD trong trường hợp IGRP là 100(RIP là 120 và OSPF là 110). I có nghĩa là IGRP.

R2# show ip route
Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, * - candidate default
U - per-user static route, o - ODR
Gateway of last resort is not set
I 192.168.4.0/24 [100/8976] via 192.168.3.1, 00:00:46, Serial0
I 192.168.5.0/24 [100/8976] via 192.168.3.1, 00:00:46, Serial0
C 192.168.3.0/24 is directly connected, Serial0
I 192.168.1.0/24 [100/8576] via 192.168.3.1, 00:00:46, Serial0
C 192.168.2.0/24 is directly connected, Ethernet0
I 192.168.6.0/24 [100/8976] via 192.168.3.1, 00:00:47, Serial0
C 192.168.9.0/24 is directly connected, Loopback2
C 192.168.8.0/24 is directly connected, Loopback1
C 192.168.7.0/24 is directly connected, Loopback0
__________________
Theo: Viet Professionals Co. Ltd. VnPro ®

adminphuong vắng mặt   Trả lời ngay kèm theo trích dẫn này
Gửi trả lời


Công Cụ
Xếp Bài

Quyền Hạn Của Bạn
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is Mở
Hình Cảm xúc đang Mở
[IMG] đang Mở
Mã HTML đang Tắt




Bây giờ là 09:52 PM. Giờ GMT +7



Diễn đàn tin học QuantriNet
quantrinet.com | quantrimang.co.cc
Founded by Trương Văn Phương | Developed by QuantriNet's members.
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.